The DIY LiBCM Kit installation instructions span four pages:
Q: How long does it take to perform this conversion?
A: First-time installers should expect to spend a full day installing the DIY LiBCM Kit.
A: Subsequent installations should take around four hours.
Q: What tools are required to perform this conversion?
-2.0 mm flat head screwdriver (included with kit)
-2.5 mm hex key (included with kit)
-T30 bit (to remove IMA cover)
-8 mm wrench (to remove bolt near IMA switch)
-8, 10, 11, 12 & 13 mm sockets, with extension
-#2 phillips screwdriver
-#3 phillips screwdriver (to remove IMA switch bus bar)
-3/16" flat head screwdriver (to remove IMA connectors without pulling on wire harness)
-Voltage Meter with at least 200 VDC range (to verify voltages prior to touching HVDC components)
-7/8" hole saw (not required for 18S+/18S-/12S+)
-1.25" hole saw (recommended)(to oversize junction board holes)
-5/32", 3/16" & 5/16" drills
-wire stripper/cutter/crimper (one or more tools)
-utility knife
-Hacksaw (to modify fuse & switch plastic covers)